2VB1: Difference between revisions

924 bytes added ,  18 February 2011
Line 2: Line 2:




* use generate_XDS.INP to obtain a good starting point
* use [[generate_XDS.INP]] to obtain a good starting point
* edit XDS.INP and change the following:
* edit [[XDS.INP]] and change the following:
  ORGX=3130 ORGY=3040  ! for ADSC, header values are subject to interpretation; better inspect the table in IDXREF.LP!
  ORGX=3130 ORGY=3040  ! for ADSC, header values are subject to interpretation; better inspect the table in IDXREF.LP!
  TRUSTED_REGION=0 1.5 ! we want the whole detector area
  TRUSTED_REGION=0 1.5 ! we want the whole detector area
Line 11: Line 11:
  MAXIMUM_NUMBER_OF_JOBS=8
  MAXIMUM_NUMBER_OF_JOBS=8


For all the sweeps, processing stopped with the usual error message after the IDXREF step.
For all the sweeps, processing stopped with an [[Problems#IDXREF_ends_with_message|error message]] after the IDXREF step. By inspecting IDXREF.LP, one should make sure that everything works as it should, i.e. that a large percentage of reflections was actually indexed nicely:
 
...
  63879 OUT OF  72321 SPOTS INDEXED.
...
***** DIFFRACTION PARAMETERS USED AT START OF INTEGRATION *****
REFINED VALUES OF DIFFRACTION PARAMETERS DERIVED FROM  63879 INDEXED SPOTS
REFINED PARAMETERS:  DISTANCE BEAM AXIS CELL ORIENTATION   
STANDARD DEVIATION OF SPOT    POSITION (PIXELS)    0.53
STANDARD DEVIATION OF SPINDLE POSITION (DEGREES)    0.12
It may be possible to adjust some parameters (for COLSPOT) so that the error message does not occur, but it is not worth the effort. So we just change
JOBS=XYCORR INIT COLSPOT IDXREF DEFPIX INTEGRATE CORRECT
to
JOBS=DEFPIX INTEGRATE CORRECT
and run "xds_par" again. It completes after about 5 minutes on a fast machine, and we may inspect CORRECT.LP .


== timings for processing sweep "e" as a function of MAXIMUM_NUMBER_OF_PROCESSORS and MAXIMUM_NUMBER_OF_JOBS ==
== timings for processing sweep "e" as a function of MAXIMUM_NUMBER_OF_PROCESSORS and MAXIMUM_NUMBER_OF_JOBS ==
2,684

edits