2,684
edits
XDS.INP: Difference between revisions
Jump to navigation
Jump to search
→Keywords which affect completeness and resolution limits
(→Keywords for space group assignment: hint about REMOVE.HKL) |
|||
| Line 67: | Line 67: | ||
:the default is "7000. 30000." but the first number is probably on the low side. See [[Determining_VALUE_RANGE_FOR_TRUSTED_DETECTOR_PIXELS]]. | :the default is "7000. 30000." but the first number is probably on the low side. See [[Determining_VALUE_RANGE_FOR_TRUSTED_DETECTOR_PIXELS]]. | ||
;[http://www.mpimf-heidelberg.mpg.de/~kabsch/xds/html_doc/xds_parameters.html#MINIMUM_ZETA= MINIMUM_ZETA] | ;[http://www.mpimf-heidelberg.mpg.de/~kabsch/xds/html_doc/xds_parameters.html#MINIMUM_ZETA= MINIMUM_ZETA] | ||
:the default of 0. | :the default of 0.05 is good. A lower value increases completeness. See [[MINIMUM_ZETA]]. | ||
;[http://www.mpimf-heidelberg.mpg.de/~kabsch/xds/html_doc/xds_parameters.html#INCLUDE_RESOLUTION_RANGE= INCLUDE_RESOLUTION_RANGE] | ;[http://www.mpimf-heidelberg.mpg.de/~kabsch/xds/html_doc/xds_parameters.html#INCLUDE_RESOLUTION_RANGE= INCLUDE_RESOLUTION_RANGE] | ||
:the default is "20.0 0.0" but it would be good to change this to sensible values for your data set, e.g. 50.0 for the lower resolution limit and the limiting resolution, where the average signal-to-noise ratio drops below 1, for the upper limit (the latter number could be obtained from [[CORRECT.LP]]). | :the default is "20.0 0.0" but it would be good to change this to sensible values for your data set, e.g. 50.0 for the lower resolution limit and the limiting resolution, where the average signal-to-noise ratio drops below 1, for the upper limit (the latter number could be obtained from [[CORRECT.LP]]). | ||